Izdelki za 24 v 20a (4)

The output shaft of the HSH swivel motors has radial and axial hydrostatic bearings. Here, radially and axially arranged bearing pockets are supplied with pressurized oil via a separate pressure connection. As a result, the output shaft is centered radially and axially between liquid cushions and all metallic contact surfaces are permanently separated from each other by a thin liquid film. This eliminates wear caused by metallic friction in any operating state, even at zero speed compared to hydrodynamic plain bearings. In conjunction with highly dynamic control valves and angle of rotation sensors, these actuators are preferably used in controlled systems in which disturbance variables such as friction and the stick-slip effect must be reduced to a minimum. Furthermore, due to the lack of internal seals, they are ideal for test series with large numbers of load cycles where an interruption, e.g. due to the replacement of internal seals, is not permitted. Specific torque [Nm/bar]:2,05 Operating pressure [bar]:280 Nominal torque [Nm]:574 Swivelling angle [ degrees° ]:120

Neben unse­rem Lie­fer­pro­gramm der Ein­zel­kom­po­nen­ten bie­ten wir auch Kom­plett­ar­ma­tu­ren (Antrieb+Armatur) und spe­zi­ell auf Ihre Bedürf­nis­se zuge­schnit­te­ne Son­der­lö­sun­gen an. Pro­jekt­be­zo­gen oder als Seri­en­kom­po­nen­ten, zahl­rei­che Vari­an­ten und Optio­nen, geplant, kon­stru­iert und gebaut bei ARIS

Das BC60 ersetzt das BC30 und BC40 und ist speziell auf die Anforderungen der Industrie abgestimmt, lässt sich jedoch ebenso auf landwirtschaftlichen Biogasanlagen sowie in kommunalen Kläranlagen einsetzen. Fernwartung über das Internet ist möglich. Defekte Bauteile, wie zum Beispiel Gassensoren, können Kunden in Eigenregie austauschen. Das BC60 verfügt über bis zu 8 Messeingänge.

The output shaft of the HSH swivel motors has radial and axial hydrostatic bearings. Here, radially and axially arranged bearing pockets are supplied with pressurized oil via a separate pressure connection. As a result, the output shaft is centered radially and axially between liquid cushions and all metallic contact surfaces are permanently separated from each other by a thin liquid film. This eliminates wear caused by metallic friction in any operating state, even at zero speed compared to hydrodynamic plain bearings. In conjunction with highly dynamic control valves and angle of rotation sensors, these actuators are preferably used in controlled systems in which disturbance variables such as friction and the stick-slip effect must be reduced to a minimum. Furthermore, due to the lack of internal seals, they are ideal for test series with large numbers of load cycles where an interruption, e.g. due to the replacement of internal seals, is not permitted. Specific torque [Nm/bar]:32,80 Operating pressure [bar]:280 Nominal torque [Nm]:9184 Swivelling angle [ degrees° ]:120